This version of a clouser style baitfish imitator has two or more brass beads on the hook shank that "Click" together when the fly is stripped through the water.
Step 1
Place two brass beads on the hook shank.
You will probably have to crimp the barb of the hook down to get the brass beads on the shank.
Step 2
Tie a ball of thread just prior to the curve of the hook as a stop for the brass beads.
Coat with Head cement or epoxy, depending on where you are fishing this fly.
Insure the Glue dries before allowing the beads to contact the Thread ball and glue.
Step 3
Tie your Dumbell eyes of the bottom of the hook shank allowing room for the brass beads to move.
Step 4
Tie the wing on the fly as you would on a normal clouser style fly.
Allow the wing to stay high. If the wing is tied tightly to the hook,
it will inhibit the movement of the brass beads.
Step 5
Tie in several strands of Crystal Flash - Pearl or to match the wing material.
Whip finish off and coat with head cement. Done.