Left Side View
The receiver mounts on the stock bumper
attachment points on the frame.
Rear View
The Bevels provide clearance for the steering
sector. A reinforcing triangular plate was welded behind the
receiver tube covering the end of the tube and extending down to
the bottom of the crossmember.
Right Side View
The Stock Bumper bolts to angle iron that's
welded to the top of the receiver. Some trimming of the Bumper
Bracket is necessary to clear the body work.
Front View
A hole was cut in the Bumper to access the
receiver.
Receiver and Bumper installed
Side View
With the Receiver installed, the Stock Bumper
mounts above and forward of the stock location. This leaves room
for a High Lift Jack that clamps between the bumper brackets, and
a shovel that bungees to the High Lift. The pin for the hitch is
accessed from the top after removing the jack.